The Walls

Page 1 | Page 2 | Page 3 | Page 4 | Page 5

MGRO with one wall removed. To do this, 4 bolts were removed — one each at the top and bottom of each wall frame. The one wall section was then carefully pushed out and lowered to the ground.

In this picture, the siding is almost finished for the wall sections; the roof has not yet been built at this point. The walls have been mostly painted black on the inside, and the outside of the floor frame has been painted white to match the siding.

The removed section is the one with the door in it. If I had it to do over again, I'd construct the door so that it opens out rather than in! The door is just wide enough to fit a C8 case through with a few inches to spare. Some people may prefer a wider door — it's just a matter of adjusting the framing of that one wall to accomodate the size required.